Filter schließen
 
  •  
  •  
von bis
Für die Filterung wurden keine Ergebnisse gefunden!
ECUMASTER CAN SWITCH BOARD V3 ECUMASTER CAN SWITCH BOARD V3
CAN SWITCH BOARD V3 A CAN switch board is a tiny device to allow easy transfer of up to 8 switch states and 8 analog signals over the CAN bus. In addition to this, the device has 4 built-in low side outputs that can be activated with a...
130,00 € *
Ecumaster CAN-BUS MODULE Ecumaster CAN-BUS MODULE
EMU Additional Modules Two additional modules are available to extend standard EMU performance: the DBW module and the CAN bus module. The DBW module is required to allow EMU to control the electronic throttle and it is connected to the...
119,00 € *
Ecumaster DBW MODULE (ELECTRONIC THROTTLE) Ecumaster DBW MODULE (ELECTRONIC THROTTLE)
EMU Additional Modules Two additional modules are available to extend standard EMU performance: the DBW module and the CAN bus module. The DBW module is required to allow EMU to control the electronic throttle and it is connected to the...
99,00 € *
ECUMASTER DATA LOGGER - EDL-1 ECUMASTER DATA LOGGER - EDL-1
The EDL-1 data logger is a “must have” for any professionals using the EMU, EMU CLASSIC and the EMU BLACK device. Utilizing serial communication, this device is able to record over 200 data channels with a frequency of 25Hz. Use of the...
149,00 € *
Ecumaster EGT to CAN module Ecumaster EGT to CAN module
EGT to CAN The EGT to CAN module collects input signals from 8 EGT probes (K-Type thermocouples), converts the probe voltage into a numerical temperature figure and sends the appropriate data via a CAN bus. The module is fully...
139,00 € *
Ecumaster GPS to CAN Modul Ecumaster GPS to CAN Modul
Ecumaster GPS module assures high accuracy position tracking with 20Hz update rate. The module is able to use GPS, Glonass and Galileo satellites using the included external active antenna. Thanks to a built in 3-axis accelerometer and...
299,00 € *
MAC Ladedruckregelventil MAC Ladedruckregelventil
49,00 € *
Ecumaster Lambda to CAN Ecumaster Lambda to CAN
LAMBDA to CAN Ecumaster Lambda to CAN controller is a compact device used to control a Bosch LSU 4.9 wideband oxygen sensor and transmit the lambda reading via CAN-BUS. Two programmable 0-5V analog signal lines are available, along with...
189,00 € *
Ecumaster BLUETOOTH MODULE Ecumaster BLUETOOTH MODULE
BT MODULE Bluetooth module The Bluetooth module allows to transmit ECUMASTER log data via Bluetooth communication. It makes it possible to trace all important engine parameters in real-time using Android compatible devices. There is also...
49,90 € *
Ecumaster BLUETOOTH CAN MODULE Ecumaster BLUETOOTH CAN MODULE
BT MODULE Bluetooth module The Bluetooth module allows to transmit ECUMASTER log data via Bluetooth communication. It makes it possible to trace all important engine parameters in real-time using Android compatible devices. There is also...
69,90 € *
Ecumaster USB TO CAN MODULE Ecumaster USB TO CAN MODULE
USB to CAN The ECUMASTER USBtoCAN is a USB interface that allows the user to connect to the CANbus network. It supports CAN 2.0A and CAN 2.0B standards. It is equipped with a LED status diode for fast diagnostic and a 120 Ohm terminator...
119,00 € *
Zuletzt angesehen